Preparation:

• Ensure proper isolation of the working surface from saliva using a rubber dam or cotton rolls and a saliva ejector.
• Follow standard methods of cavity preparation for hard tooth tissues.

Pulp Capping (if necessary):

• In case of a deep cavity requiring pulp capping, apply calcium hydroxide material and isolate with glass ionomer cement close to pulp dentine.
• Leave the rest of the dentine surface open for adhesive treatment.

Application of SafeEndo ReCreate Bond 7:

• Shake the dropper bottle well before use.
• Apply 1-2 coats of SafeEndo ReCreate Bond 7 on the prepared tooth surface by gently rubbing for 15 seconds.
• Slightly dry the adhesive with air within 5 seconds (to prevent splashing), followed by thorough drying for another 5 seconds with a strong air flow.

Photopolymerization:

• Provide photopolymerization using a light source emitting wavelengths of 400-500 nm within 20 seconds.
• Keep the waveguide endface in close proximity to the curable material during curing.
• For large cavities, divide into smaller sections and provide photopolymerization for each sector separately.

Inhibited Layer:

• Do not remove the formed inhibited layer, as it promotes binding with the composite material.

Post-Application:

• Remove excess material from the bottle's nozzle and tightly close it immediately after use to prevent solvent evaporation.

Caution:

• Do not use eugenol-containing materials, as eugenol disrupts the adhesive's structuring.
• In case of accidental contact with oral mucosa, eyes, or skin, rinse the affected area with a large amount of water.